The Firestone QuickSeam Pipe Boot Seal is designed for integrating pipework up to a diameter of 150mm. This type of seal is a fire resistant, watertight and durable roofing solution. For quick and easy installation, the pipe boot has a self-adhesive and it is recommended to slide the pipework through post-installation. QuickPrime is required with this pipe boot.
Firestone Contact Adhesive has many uses including adhering EPDM membranes to upstand, masonry and vertical surfaces and as a deck adhesive on old concrete and asphalt. When applying to either upstands or decks, make sure the adhesive is touch dry before securely applying the membrane. If the membrane is applied when the adhesive is still wet, you may find bubbles start to appear under the membrane itself. A 2.3L tin of green contact adhesive contains between 7.5 and 10m2 of coverage.
Firestone QuickPrime Plus is a primer that is designed for use as an activator for QuickSeam detailing products and to effect waterproof seals. This primer is necessary to use a variety of Firestone products including Formflash, Cover tape, Corner flashing and Walkway pads. You must ensure the primer is touch dry before applying to surfaces or other products.
Edge trim measuring 2500mm is used on roof edges that are not attached to walls or a gutter. Specially designed with a raised upstand to direct water towards the gutter. This edge is durable and comes pre-drilled and pre-foamed for easy installation. All fixings and clips are supplied.
termination bar measures 3000mm is a solid aluminium retaining bar with predrilled holes, used for securing EPDM membranes to upstands. Other uses include anchoring the membrane under lead flashings, parapets and rooflights. It can also be used alongside water block mastic to seal adjacent flat roofs.
Firestone 750ml spray contact adhesive is used for adhering EPDM to vertical surfaces and can be used on bricks, wood and many other substrates. Installation Tip Shake thoroughly prior to use. Apply a thin even coat to the membrane and substrate. 750ml covers approx 1 - 1.5m2.
Quickseam Batten Coverstrip is a 6 inch semi-cured strip of EPDM laminated to Quickseam tape. General uses include sealing and covering membrane seams. As a rigid tape, it will not stretch around corners but is a durable solution with watertight properties. It is ideal for DIY roofing projects as it's easy to install and provides a high quality finish. For best results, must be used with Quickprime and surfaces must be clean and dry prior to application. Sold per metre and whole roll measures 30.5m.
Firestone circular corner flashing is a round piece of uncured EPDM laminated to Quickseam tape for easy application to outside corners. It can also be used as a cover patch for general small repairs. Offers the same durability and watertight properties as large pieces of EPDM flashing.
This external gutter corner provides a sturdy and long-lasting 90-degree external corner to neatly join two roof gutter pieces. Available in black, white or anthracite and is easy to install with superglue.